Instructions: Jag Brush^TM   for Cables

Instructions

It is easy to use a Jag Brush^TM for cables. Pierce the patch at the pointed tip, and pull the patch over the connector. Solvent can be dripped on the patch now or it could be pre-soaked before pulling it across the connector. One has the option to pull a lubed patch through the loop at the other end. After feeding a cable through the bore, connect the brush to the cable. Pull the combo through for double or triple purpose cleaning.

Our Jag Brush^TM for cables works best when used with our Triangle Patches ^TM. But it may be used with square patches.

Do not use a square patch larger than recommended, or else the combo might be tighter in the bore than one wants. Below are maximum dimensions.

Jag Brush^TM Caliber --> Max Square Patch (inches)
17 --> 0.75 x 0.75
20 --> 1.0 x 1.0
22/223/5.56 --> 1.25 x 1.25
243/6 --> 1.25 x 1.25
25/6.5 --> 1.5 x 1.5
270/7 --> 1.75 x 1.75
30/308/7.62 --> 2.0 x 2.0
32/8 --> 2.25 x 2.25
338 --> 2.25 x 2.25

Single Purpose

When patches are not used at either end, our Jag Brush^TM acts as a typical single-purpose bore brush for cables.

Double Purpose

When a patch is not used at the loop end, our Jag Brush^TM acts as a patented dual-purpose bore brush.

See Video

See video here.

Patent Pending

Utility patents are pending in the USA and in other countries.